I’m planning to run a Boss RV-500 (stereo reverb) and Boss DD-500 (stereo delay) in parallel to each other and then out in true stereo to two separate amps, as part of a W/D/W rig. Can you do this with the ML10X and keep the signals in true stereo? Will the left signal of the RV-500 merge with the left signal of the DD-500 after the parallel routing and then get sent to my left amp? Or will both the left and right get merged into one mono signal after the parallel routing and then split into two identical signals that then are sent to my two amps?
The two parallel stereo signals will have be merged or summed into a single stereo signal at some point to achieve a stereo output regardless of the device being used. The two sides can remain separated so output 1 of the delay and output 1 of the reverb are sent to output 1 (tip) of the ML10X and output 2 of the delay and output 2 of the reverb sent to output 2 (ring) of the ML10X.
1 Like
Ok, so in other words the stereo remains stereo all the way to the amps?
It can unless it then passes through a mono pedal or chain.
1 Like
Is it possible to run more than two pedals in parallel?
Never tried it but would imagine so.