Relay Switching activating on Boot up

Morningstar Gear MC Pro Series MIDI Controller
1

Hi folks,

I was wondering if anyone else has this issue. I use one of the relay ports on my mc8 pro to control the channel switching on the science mother preamp. During the boot up of the controller a relay message is sent activating the higher gain channel. This previously didn’t happen, I think it started after one of the more recent updates.

I’m so close to just modding the channel footswitch with a midi module like the ones oscillator devices makes, but it seems a little intimidating

2

There is a Relay port setting under controller settings >> general configuration which sets the default state of the relays. NO = Normally Open which is the default relay state. NC is Normally Closed which is the Relay engaging.

image
image390×356 15.5 KB

3

Sorry for the delay on the response, this explanation made it make sense. Thank you!