I am playing with three ML10X switchers in my rig (controlled by an MC8), and have hit a snag- every time I turn everything off and back on again, the device ID of each of my switchers reverts back to “omni”, and therefore receive (and respond to) all the same messages, rather than the specific ones that are meant for each individual unit.
My first instinct is always user error, but I have reassigned device IDs and saved settings many times. It always works fine until I turn all the units off and then start them up again, and then I’m back in “omni”. None of my other controller settings reset or revert.
Has anyone else experienced this? Morningstar, is there anything you can do to help?
This is really getting into the weeds, but could you make a firmware that combines this fix with the mirroring of output tip to output sleeve? I need both in one for the front of my pair of ml10xs for my wdw rig to function properly!