I’ve now received the ML10x, but unfortunately I don’t get any sound/signal.
If I go in with a guitar, there should be a signal coming out, even if no loop is activated, right?
This is unfortunately not the case!
Did I miss something or is the device defective?
When I was building my setup I started with a “Thru” preset that just connected input to output.
Then one by one added a preset with an additional loop in each until I could confirm that all of my cables were connected (and built) correctly, when the Thru preset and all pedals (in bypass) were working the same.
Thanks! I didn’t know I had to lay an empty path.