ML5 light stopped working

One of the lights on the loops (E) stopped working…still “clicks” and functions to control the loop on and off but the light does not seem to work anymore on that loop. Any fixes ?

Is the unit still under warranty? If so, you can just drop us an email about this.

One thing you can check if you are able to is to

  1. Remove the back plate
  2. Remove the top circuit board by removing all the jack nuts, and you can slide the board out after.
  3. After which, you can see the board that the LED buttons are soldered to. Just check the pins of the affected LED and see if there is any issue with the soldering

Yeah - I’m still under warranty - purchased 4/20/21.

I can try open it up in the next couple days and see what I see going on with that solder to the LED

Thanks,
Jayson