Still new to Midi in general. I created my chain in the beta ml10x.(i have the rev b model). I went to the mc6 editor and created a simple toggle on preset While switching to another preset that had a tonex preset on it i created a bypass for the pedal. I had the hardest time getting the ml10 to read the message while using the ignore midi option. I got it to work briefly until i went to create another scenerio for another stomp pedal. It all stopped reading again. This morning i woke up thinking of doing a factory reset but before i did i decided to test to make sure it didnt work. I disconnected the usb from ml20 then booted everything up and it all was working. My question since i still dont know what caused the issue is. Having tge usb connected does it cause problems with ignore midi option. I had set ml10 to channel midi 3 and id 3 . I would like to know what caused this situation. Since i did unplug the usb from ml10 just before start up. It was the only thing i think could have been different . Did i answer my own question or was it another reason. Also, i assume you can run omni id since i only have one unit but being new i just created an id for it anyway.