Good evening. I have a small problem. I have a Walrus Audio M1 V2 (modulation) pedal. I programmed it as follows:
Message 1:
release action -Programm change
Send Programm change - PC No.1
Message2:
release action - preset rename
Current active name - name
Message 3:
release action -Programm change
Send Programm change - PC No.1
Message4:
release action - preset rename
Current active name - name
etc…
and at the end these messages;
Message 27 :Press action - utility
manage preset message scroll
set number of message to scroll
number of message: 2
then:
Message 28: long press action - pos. 1 to turn the pedal ON
Message 29: Long press action -pos. 2 to turn the pedal OFF
Message 30: long press: toggle preset
all works fine. I can scroll through the preset and choose the desired one while being off , the with a long press action i turn it ON or OFF
Last week I bought the Walrus Mako D1 V2 (delay), so it’s the same Mako series as the M1.
So I copied the entire preset and applied it to the adjacent knob.
And then, surprise, the pedals stopped working properly.
As soon as the delay is copied, it messes up the modulation preset.
I don’t understand why.