Hi I’m relatively new here. I have three pedals programmed in my MC6 MK2, the MIDI commands in the editor are all routed to the MIDI channel pertaining to each effect box. I’ve noticed that any instruction I’m sending is going to all three, despite me giving each box their unique MIDI channel. I notice the row of midi numbers that run across the top of the command fields is set to ALL by default. Changing anyone of these numbers changes the channel of everything connected to the MC to the same channel which is undesirable. I can’t find the means to get each effect working independently. Can someone advise me please?
Card created
This is an automatically generated message
A Trello card has been created for this request: MIDI device editor MIDI channel
that strip is just a filter in the editor so you can see only the messages pertaining to each device. If you have your messages sending to specific channels, but devices on other channels are also responding, then those devices are either set to the wrong channel or an omni-channel setting. There are even some devices that only work in omni, where they only way to separate them out is to physically put them on a different port.
A few diagnostic questions:
- What pedals are they?
- How have you connected them to the MC6 mkii?
- And are you certain you have them on different channels?