MC8 Pro → Strymon TimeLine (V1) — MIDI clock won't lock on bank entry

Setup: MC8 Pro sending MIDI clock to a Strymon TimeLine (original, DIN MIDI) over 5-pin DIN. Each song lives in its own bank; entering a bank sends a “Start MIDI Clock” bank message at that song’s BPM. Six presets per song act as scenes (each sends the TimeLine a Program Change to recall a preset).

Problem: On entering a bank, the TimeLine doesn’t lock to the clock — the delay warbles and the tempo display stays red. It only settles/locks after I change scenes (send PCs) ~3 times. I want it to lock immediately on bank entry.

Already ruled out:

  • TimeLine MIDICL = ON and TAP = GLOBAL on every preset
  • Reproduces on a bare MC8 → TimeLine DIN cable, nothing else connected
  • Happens whether the presets use tap-division (TAPDIV) subdivisions or fixed ms delay times
  • Removing the “Stop MIDI Clock” bank message (leaving only Start) made no difference
  • Only one clock sender — the bank On-Enter message; scene switches send only PC, no clock/tap

Question: What’s the correct MC8 Pro configuration to stream stable, continuous MIDI clock so the TimeLine locks tempo immediately on bank entry? Is there a global clock-output setting, a “send clock continuously” option, or an ordering/timing issue with sending Start Clock + PCs on the same bank entry that I’m missing?

The delay warbling is due to the Timeline calculating the new tempo from the MIDI Clock. This process isn’t instant. It’s the same warble as turning the Time knob on the Timeline.

I don’t think there’s any way to get rid of this, except maybe using a CC message instead to set the Time parameter instantly.