I have an issue where the bank jumps on the mc6pro don’t work correctly. It jumps to a different bank. Strangely, this behavior does not occur when connected to the editor.
1 Like
Check the Custom Bank Arrangement setting under the Controller Settings tab, and make sure that it is turned off. Let me know how that works for you.
Allright, I fixed this by disabling the custom bank sequence.
I am not sure about the intended functionality of the custom sequence. Previsously it only affected the Bank up and down feature, but not the bank jumps. Now it affects bank jumps as well. I can work with both scenarios, as long as they remain the same in updates. Last practice session I was all over the place 
Ah, I was just writing my previous reply while you posted this suggestion
Thanks for the update. Yeah, the custom bank arrangement feature was not consistent across updates (and its our fault, sorry!). The intention was for bank jumps and engage preset messages to engage the underlying bank (in the default bank sequence) instead of the custom bank sequence, so that when you rearrange the banks, you won’t need to update your engage presets and bank jumps.
I’m a new user and I’m having similar issues with Bank Jumping. I have a home page (bank 1, page 1) that allows me to jump to Drives (bank 1, page 3) and Wet (bank 1, page 2).
Drive and Wet are set up so that button A does a bank jump to Last Used Bank / Page or Page.
When the MC6Pro first boots, it works fine. However each subsequent attempt doesn’t do the bank jump.
Custom bank Sequences are turned off. Also, Load preset data into Editor using Switch Press is off.
There are other weird things happening. At times, it will jump to a random bank.
I’ve have a video, but as a new user, I’m not able to add attachments yet.