When I engage loop A ring on my ML10X (firmware 1.2.0) in advanced mode, it adds a clean blend.
When I engage the same loop in standard mode, I don’t get the clean blend, without any routing differences.
Even if I just connect the loops output directly to its input, I still get the clean blend. I’ve swapped every cable on the loop, restarted, even completely rebuilt the preset. Not sure what’s going on, any ideas?
Installing the latest beta firmware fixed the clean blend issue but now the bypass / engage selected loops commands no longer work (they had worked in advanced mode previously). If I use the commands the ML10X now freezes if it is in advanced mode. It also freezes if I use the advanced mode “Cut Output” or “Restore Output” commands. My device is a Rev A.
Seems like similar to issues to this: ML10X v1.2 Beta Firmware - #66 by Dannyako
Except I am not using midi, I actually have midi turned off for both my ML10X’s.
