To begin, I am an idiot.
I soldered all of my TRS-to-L/R TS cables to length assuming I could use Send A as the send and return respectively, rather than what I now seem to realize is Send A would go to two different pedals inputs, and Return A would come from those two pedal outputs.
So as it stands I will have to recut and solder everything (my bad), but it got me wondering if there was any way to allow for using Send A and a pedal in/out, Return A and another pedal in/out, etc.
Am I the only one who solders first and reads instructions later?
I assume that you are asking for a feature that requires hardware modifications.
Regarding the confusion, it makes a whole lot more sense when you start considering the ML10x as a stereo loop switcher with 5 loops. One stereo jack connects to an input or output and goes to the input or output of the pedal. For a stereo pedal the part that handles the left and right sides will be wired to the tip or ring of the connector. Both sides being separated from each other. The ML10x gives you the option to wire a pedal to the ring and one to the tip. It is important that if the input from pedal A is connected to the tip, that the output it also connected to tip. I believe you got this figured out by now … Good luck with the soldering work. Maybe some of the wires you soldered can still be used for another loop?
Good luck with the soldering work. Maybe some of the wires you soldered can still be used for another loop?