Controlling position 1 and Position 2 based on Bank Preset of MLX10 loop load

Hello and good day,
I am using MLX10 and MC6 Pro to control pedals on my board.
I have a chain in MLX10 Bank 1 some in chain are bypassed. On Board 1 load I em setting Bank 1 Preset 0 on MLX10 to load up MC6, I would like to have enabled pedals highlighted in red and bypassed blue. So when I toggle and enabled to bypass the red turns to blue. When I toggle a bypassed I would like blue to red. How can I force the color on load?

You can add a Set Toggle message to your Bank Preset. In the example below, switch A, C and D toggle states will be set to engaged and highlighted red. Just check the boxes for the effects that are engaged in your ML10X preset.

Hi Brandon and good day,

On Enter Bank I am making a call to the ML10X to load Bank 1 Preset 0. This is a simple loop of pedals with some engaged and some bypassed.

What I want to happen is after the command the pedal position 1 and 2 to reflect the pedals state at the time of On Enter Bank.

Other note
Regarding the Beta, is it safe to assume simple loops invoked via MC6 Pro to ML10X will not be impacted and the Beta code change would impact Advance loops? No other simple ML10X loop and or MIDI calls to pedals are int impacted?

I might want to try the Beta, how do I obtain it?

Mike

Yes, that is what my last reply to you would allow you to achieve. Your MC6 PRO switches can be matched with your ML10X preset when you enter a bank.

The ML10X beta firmware adds the new feature and does not affect existing functions.