@james ,
Hello James. Im not sure what Im doing wrong .It should be simple but heres my problem.
I have 2 Source Audio pedals being controlled through the source audio neuro hub that is connected to my MC6. I have the latest firmware on my MC6. I am trying to use CC Scroll as the Source Audio pedals dont recognize PC messages… I have 2 different counters set up . Counter 1 scrolls 1 - 66 on my C4 and Counter 2 is supposed toScroll 1 - 33 on my Ultrawave. The counter for the C4 is scrolling the numbers for both the presets, ( counter 1) and the counter for the Ultrawave does not scroll any numbers ( counter 2). It will send the midi info and both presets scroll there respective pedals up and down but the counters are not working. I have them set to different channels and Im sending separate CC for increment and decrement to the pedals. Again the pedals are scrolling up and down but one counter is controlling both counters even though I have 2 different counters set up. Any ideas?
Why do you use 2 different midi channels for your SA pedals connected to the neuro Hub ?
No need.
Have you correctly configured each midi table to support the midi CC you are sending to each pedal ?
I have 2 hubs and no pb as this, all pedals on same midi channel.
Can you share a screenshot of your preset in the editor?
Yes, I will post up later today.
Why do you use 2 different midi channels for your SA pedals connected to the neuro Hub ?
No need.
Some of us prefer that setup for troubleshooting purposes. It eliminates a potential source of error, and allows the assignment of the same CC for the same control (effect mix, for example) on different devices.
Exactly. And I don’t use the hub for scenes. I’m just using it as a pass-through. What’s good for the goose isn’t always good for the gander.
Ok I see, that’s exact. But on the other side, you lose the possibility to activate the same CC on several pedals, but you can send several CCs.
When you have no number constraint on your midi bus, that’s certainly a working solution.
Back to your Scroll counter Pb, I use many counters on many different midi channels without Pb, just as proposed @james just show your presets there must be a pb.
I will post screenshots of my presets when I get home from WORK.
@james I figured it out.I was not correctly assigning the slot. I’m figuring it out. All good now. Thanks
@celticelk By the way, welcome to the community. Lots of good info and help here
Thanks! Just got my MC8 this week, but I’ve been scheming control setups for my rig for a while, and I expect to dive very deep on programming it very quickly.