I understand there’s a lot of potential issues here but let me see if someone can help me out.
Just now setting up my ML10X with a rather large board.
Here’s the setup:
- Input tip guitar - (input ring empty, TS cable only in)
- Send A tip to EQ - returns to A tip
- Send A ring to Compressor - returns to A ring
- Send B tip to Od pedal 1 with appropriate return
- Send B ring to OD pedal 2 with appropriate return
- THIS is where things get difficult for me:
- Send C tip goes to the Nano cortex. There is no TRS input so it is a TS cable from C tip to the Nano.
- Return C tip is Nano output L
- Return C ring is Nano output R
- Loop D is a few stereo pedals
- Loop E is some more stereo pedals
- Output tip is L
- Output tip is R
Perhaps I’m just not understanding the editor. How do I setup the looper on the patch to say the send on C is mono but now were going to also use both return channels of C? I cannot get any sound out of the left.
Thoughts and thank you!
