Can't connect editor(s) to two ML10X at the same time without using Serial connection

Morningstar Gear ML10X
1

I had previously had no issue connecting to the independent ports of my two ML10X’s. However the last couple of times I have connected I experience the following behavior:

I can connect to either just fine for my initial connection. However when I connect to the second ML10X, it refreshes the first connection to mirror it. If I change the first connection back it changes the second connection to mirror it… Ad Nauseum

As stated in the title I can use the Serial connection to connect independently. But since this was previously working just fine I thought I’d see if anyone else (with two ml10x’s… I know it’s a relatively small pool) was experiencing this?

Running Chrome Editor on M1 Macbook pro, using ML10X v1.2 firmware

2

Nobody?

Still experiencing this in Chrome (and webapp) editor. I have to either load both using the serial method or load one of the ml10x in the desktop editor and the other in chrome/webapp editor. Seeing other oddities where preset names and connections glitch out or go blank also. Tried clearing the cache and doing a hard reload in chrome, but no luck.

3

Given that your ML10X is running the 1.2 beta firmware, you need to use the beta ML10X editor… are you using the beta editor? https://editor-beta.morningstar.io/

4

Well, I guess I wasn’t (thought I was), but I experience the same thing there.

5

Sorry for the delay. I just tested and this is a problem. Looking into it now

6

Ok I’ve fixed the issue - just deployed the update. thanks for bringing it up!

7

Thanks for being you! I’ll check it out tomorrow