Since last FW update (3.12.3), pressing a bank jump switch on MC6 Pro send me to the previous bank (ie., sends me to bank 6 instead of bank 7), except Bank 1 which is correctly interpreted. However, this problem disappears the moment I connect to the editor.
A rapid fix would be appreciated, because I cannot use the controller stand-alone.
Thanls.
I didn’t experience an issue like this. Can you confirm if your “use custom bank sequence” under the controller settings tab is turned off?
That solved the problem, thank you. Maybe the custom sequence got enabled during the update, I had never visited that setting.
I’m having the same issue. It keeps jumping to banks 29 or 30 and I to reset each time to get back to my bank. Please help!
It is seeming to get worse… now when I just connect the unit to loopy pro it jumps to bank 30!
What controller and firmware version are you using?
Check to make sure that it isn’t the MC receiving a PC message that causes it to jump bank. The MC will not jump bank on it’s own unless the function is triggered by an external event like a switch press or incoming MIDI message.
Try changing the MIDI channel on your MC and see if the issue persists.