Bank Jump Not Working

When I input a bank jump using a press action it is not jumping to the bank I input in the action. I have it set up for a bank jump to bank 5. I am not sure if the command is wrong or not. Thanks!

If using firmware v3.8.3 or earlier, be sure to exit editor mode first

I am using the most recent version. Whenever I set up a press action to a bank jump nothing happens. Shouldn’t a simple press action a bank jump where I name the bank do that?

Can you confirm what is the most recent firmware you are using?

In v3.8.3 and earlier, this function is blocked while in editor mode because a switch press loads the settings into the editor. If it is not blocked, pressing the switch will load the settings into the editor AND jump to a different bank.